Pillows & More
Rhinestoned pillows for the home — Madison Avenue, Strass, Gatsby, Monte Carlo, Montaigne, Fifth Avenue and the Rainbow shaped pillow — along with flasks and a placemat.
A rhinestoned pillow behaves differently from a rhinestoned garment: it sits still, under lamplight rather than moving light, so the stones read as texture across the surface instead of flashing. That argues for one or two as the accent on a plain sofa or bed rather than a matched set — the effect comes from contrast with flat fabric around it, and it disappears when everything in the room competes.
These are decorative pieces, so keep them where they are seen rather than crushed. The flasks and placemat carry the same stone treatment as our drinkware if you are pulling a table together.
Frequently Asked Questions
It depends on the piece. Jackets, shirts, and pillow covers use heat-set rhinestones, pressed into the fabric so the bond survives regular wear and laundering. Sneakers, heels, and drinkware are hand-placed with adhesive, because those surfaces are curved, layered, or heat-sensitive and cannot go under a press.
Both methods are permanent. They differ in what the surface will tolerate, not in how well they hold.
Not under normal wear. Heat-set stones on apparel are bonded into the fabric rather than sitting on top of it, and hand-placed stones on footwear and drinkware are set with an adhesive rated for flexing and handling.
What does cause loss is abrasion and heat: a rhinestoned sneaker scuffed against a curb, a tumbler run through a dishwasher, or a jacket dried on high. Those are avoidable, and the care answers below cover each one.
Turn it inside out, wash cold on the gentle cycle, and hang dry. Do not use bleach or fabric softener — softener leaves a residue that creeps under the stone edge and loosens it over time.
If you must use a dryer, use the lowest heat setting and pull the piece while it is still slightly damp. Heat is what breaks a heat-set bond; the same energy that made it can undo it.
Never iron directly over the stones. If the garment needs pressing, turn it inside out and press the reverse.
No. Hand wash only, in warm water with a soft cloth, and dry immediately.
A dishwasher combines everything that damages a set stone: sustained high heat, high-pressure spray, and harsh detergent. Our tumblers are double-walled and the crystal application is secure, but no adhesive is rated for that cycle. Hand washing takes a minute and the finish stays intact for years.
They are made to be worn, but they reward a little thought about where. Hand-placed stones sit slightly proud of the surface, so the wear points are the toe box and the outer edge — the same places that scuff on any shoe.
For daily wear, avoid wet pavement and abrasive surfaces, wipe with a dry soft cloth after each wear, and store them in the box rather than loose in a closet where they knock against other shoes. For performance and event wear, that care routine will keep them looking new indefinitely.
Yes. A single missing stone is a five-minute fix with a flatback rhinestone of matching size and a dot of gem adhesive such as E6000. Clean the empty setting with rubbing alcohol, apply adhesive to the stone rather than the garment, place with tweezers, and leave it 24 hours to cure.
Match the size before you buy: most of our apparel uses SS16 to SS20 stones, and footwear varies by design.